LOGIN
John Rodrigues
84
Community Expert
Mechanical Design Engineer |Founder of designwithjohn.com
 · HonnavarIndia
Share
Report
Get Link
ROADMAP

Designs for the Automated Book sorter

The book enters from the blue box ,it moves along the track belt based on the RF detection the books are diverted to its respective place by the linear actuator

Automation
CAD Design
Contributions
John Rodrigues

What you think?. If we use a bar code sensors and then designed a pick and place bot in ladder like structure By fixing a huge tray at the bottom of bot. Using bar codes the bot may find out an allocated place for respective book

John Rodrigues

Nice design and brilliant CAD models.

Winston D'souza

Fabricated the conveyor for the Automated Book Sorter project.

Winston D'souza

Fabricated the conveyor belt

5 likes 
Like
Award Contribution
Load 2 previous comments
Claran Martis
26
Community Expert
Electronics and Communications Engineer | Founder CVision (Project Leader)
 · MangaluruIndia
Share
Report
Get Link

I think fabrication can be done in most workshops. Winston D’souza can you check out for some Workshop to fabricate it?
We may have to also make a list of all required parts and then try to procure then at the earliest.

Like
1 like 
Award Contribution
John Rodrigues
84
Community Expert
Mechanical Design Engineer |Founder of designwithjohn.com
 · HonnavarIndia
Share
Report
Get Link

Sounds great Claran Martis
Looking forward for the parts list

Like
1 like 
Award Contribution
John Rodrigues
84
Community Expert
Mechanical Design Engineer |Founder of designwithjohn.com
 · HonnavarIndia
Share
Report
Get Link

We focused on keeping the design simple ,for ease in manufacturing

Like
0 like 
Award Contribution
John Rodrigues
84
Community Expert
Mechanical Design Engineer |Founder of designwithjohn.com
 · HonnavarIndia
Share
Report
Get Link

Ali Stone have you seen this ?

Like
0 like 
Award Contribution
Winston D'souza
2
Apprentice
Engineer
 · MangaluruIndia
Share
Report
Get Link

i found a workshop near my place , and the base model is ready.Claran Martis
i used three 2" metal pipes to which two metal stoppers are welded on both the sides and a shaft of 1" is passed in the middle to form a roller. for the free rotation of the roller i have used ball bearings on both the sides of roller which is welded to the base , To one of the roller a high torque dc motor is attached which will be driving the belt .

Contributions

Fabricated the conveyor for the Automated Book Sorter project.

Fabricated the conveyor belt

Like
1 like 
Award Contribution
John Rodrigues
84
Community Expert
Mechanical Design Engineer |Founder of designwithjohn.com
 · HonnavarIndia
Share
Report
Get Link

Hey this should a milestone
Post it as a new discussion

Like
0 like 
Award Contribution
Leave a reply...
DISCOVER
CHAT
ALERTS
DISCUSSIONS
FEED
New Post
Start Project
Online Users
Share Link
Help